Campbell Hausfeld IN206701AV Betriebsanleitung PDF herunterladen

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and

others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for

future reference.

For parts, product & service information

visit www

.chpower.com

IN206701AV 9/07

Operating Instructions & Parts Manual HVLP Spray Gun

HVLP Spray Gun

Description

High volume, low pressure (HVLP)

paint spray ers are de signed to de liv er

a fine finish with low overspray. The

sprayer can be used to apply various

acrylics, stains, sealers, lacquers, latexes,

and primers. This unit can be used for

painting cabinets, fur ni ture, ma chin ery,

equip ment, walls and trim work. Spray-

ers of this type are not recommended

for au to mo tive final coat. This por ta ble

unit is an ideal alternative to con ven tion-

al spray guns. The HVLP’s high transfer

efficiency pro vides pro fes sion al re sults

with much less material waste and en vi-

ron men tal con tam i na tion than other

con ven tion al spray paint ing sys tems.

Unpacking

When unpacking the sprayer, inspect

carefully for any damage that may

have occurred during transit. Make

sure any loose fittings, bolts, etc., are

tightened before putting sprayer into

service. Each sprayer has been tested

before shipment.

NOTE: The packing nut may need

additional adjustment due to the

packing material relaxing during

shipment.

The fluid used for testing the sprayer

has been drained, but some of this fluid

will remain in the spray gun. This fluid

should be flushed from the spray gun to

prevent contamination of the coating

material. Use a solvent compatible with

the coating to be sprayed.

Locking Lever For

Quick-Release Paint Cup

Air Flow Control

Material Flow

Control Knob

1 Quart Cup

Oval To Round

Pattern Ad just ment

Quick Connect Fitting

Figure 1 - Features

General Safety

Danger means a

DANGER

hazard that will cause

death or serious injury if the warning is ignored.

WARNING

Warning means a

hazard that could cause death or serious

injury if the warning is ignored.

Caution means a

CAUTION

hazard that may cause

minor or moderate injury if the warning is

ignored. It also may mean a hazard that will

only cause damage to property.

Notice means any

NOTICE

additional

information pertaining to the product or its

proper usage.

Read all instructions and safety

precautions before operating the unit.

Risk

WARNING

of fire

or explosion! Solvent and

paint fumes can explode or

ignite, causing severe injury

and property damage.

Paints and solvents containing

HALOGENATED HYDROCARBONS can react

explosively with aluminum. Always check

the product’s label before using these

materials in the unit.

Make sure the room is well-ventilated.

Avoid all ignition sources, such as static

electricity sparks, open flames, hot objects,

sparks from connecting and disconnecting

power cords, and working light switches.

Follow the material and solvent

manufacturers’ safety precautions and

warnings. Do not use liquids with flash

points less than 100 degrees Fahrenheit (38

degrees Celsius).

Do not carry TURBINE while spraying.

Keep the turbine at the maximum distance

from the spraying area.

Static electricity can be produced by

HVLP spraying. Make sure any electrically

conductive object being sprayed is

grounded to prevent static sparking. The

sprayer is grounded through the electric

cord. If an extension cord is necessary, the

cord must be a grounded, 115 volt, three

wire type cord.

Attention: Campbell Hausfeld recommends that servicing other than that shown in the instruction manual should be performed by an

authorized service facility.

Table Of Contents

Description . . . . . . . . . . . . . . . . . . . . 1

Unpacking. . . . . . . . . . . . . . . . . . . . . 1

General Safety Information. . . . . . . 1

Setup. . . . . . . . . . . . . . . . . . . . . . . .2-3

Operation . . . . . . . . . . . . . . . . . . . . . 4

Maintenance. . . . . . . . . . . . . . . . . .4-5

Troubleshooting. . . . . . . . . . . . . . . . 6

Warranty. . . . . . . . . . . . . . . . . . . . . 10

1 2 3 4 5 6 7 8 9 10

Inhaltsverzeichnis

Seite 1 - HVLP Spray Gun

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect you

Seite 2 - General Safety (continued)

10Operating Instructions and Parts ManualLimited Warranty1. DURATION: From the date of purchase by the original purchaser as follows: Standard Duty Pa

Seite 3 - Setup (continued)

Figure 2 - Thin Material Needle And Nozzle Kit3. The all purpose material needle and noz zle have three groove rings as shown in Figure 3 below.Figur

Seite 4 - Preparation (continued)

3Operating Instructions and Parts Manual6. Install the appropriate needle/nozzle assembly se lect ed for the material to be sprayed (Fig. 2, 3 &

Seite 5 - Maintenance (continued)

4 Operating Instructions and Parts Manual6. Attach the air hose quick-connect fitting to the gun. The quick-connect NOTICE fitting outer sleeve is

Seite 6 - Troubleshooting Chart

53. Place the parts and the paint cup in a bucket or other suitable container. Soak the parts in a suitable solvent, or in soap and water if latex wa

Seite 7

6Operating Instructions and Parts ManualNo material flowSlow material flowMaterial leakSpray will not shut offPulsating sprayExcessive overspray1. Dis

Seite 8 - Call 1-800-626-4401

7Troubleshooting Chart Symptom Possible Cause(s) Corrective ActionSpray not uniform (spitting)Poor patternOverheatingPoor air flowSpray tip clogs1.

Seite 9 - Replacement Parts Kit

8Operating Instructions and Parts ManualFor Replacement Parts, or technical assistance, Call 1-800-626-4401Please provide following information:-Model

Seite 10

Canister assembly (Includes items 2-4) SK205800AJ 1 ✦ Trigger assembly (Includes items 9-11 & 22) SK206100AJ 1 ▲ Air flow control kno