Campbell Hausfeld SB504000 Betriebsanleitung PDF herunterladen (Seite 4)

25 Sp

Modelo SB504000

Notas

Operating The Tool

LUBRICATION

This tool requires lubrication before

using the tool for the first time and

before each use. If an inline oiler is

used, manual lubrication through the

air inlet is not required on a daily basis.

The work

surface

can become damaged by excessive

lubrication. Proper lubrication is the

owner’s responsibility. Failure to

lubricate the tool properly will

dramatically shorten the life of the

tool and void the warranty.

1. Disconnect the air

supply from the tool to

add lubricant.

2. Turn the tool so the air

inlet is facing up. Place

4-5 drops of 30 W non-

detergent oil into air

inlet. Do not use

detergent oils, oil additives, or air

tool oils. Air tool oils contain

solvents which will damage the

tool’s internal components.

3. After adding oil, run

tool briefly. Wipe off

any excess oil from the

cap exhaust.

RECOMMENDED HOOKUP

The illustration below shows the

recommended hookup for the tool.

The trigger must be released to reset

the tool before another fastener can be

driven.

CHECKING THE WORK CONTACT

ELEMENT (WCE)

Check

the

operation of the Work Contact Element

(WCE) trip mechanism before each use.

The WCE must move freely without

binding through its entire travel

distance. The WCE spring must return

the WCE to its fully extended position

after being depressed. Do not operate

the tool if the WCE trip mechanism is

not operating properly. Personal injury

may occur.

1. Disconnect the air

supply from the tool.

2. Remove all

fasteners

from the

magazine

(see

Loading/ Unloading).

3. Make sure the trigger

and work contact

element (WCE) move

freely up and down

without sticking or

binding.

4. Reconnect

air supply

to the tool.

1. The air

compressor

must be able to

maintain a

minimum of

60 psi when

the tool is being used. An

inadequate air supply can cause a

loss of power and inconsistent

driving.

2. An oiler can be used to

provide oil circulation

through the tool.

A filter can be used to

remove liquid and solid

impurities which can rust or “gum

up” internal parts of the tool.

3. Use 3/8" air hoses with

a minimum working

pressure of 150 psi. Use

1/2" air hoses for 50'

run or longer. For

better performance, install a 3/8"

quick plug (1/4" NPT threads) with

an inside diameter of .315" (8mm)

on the tool and a 3/8" quick coupler

on the air hose.

4. Use a pressure regulator on the

compressor, with an operating

pressure of 0 -125 psi. A pressure

regulator is required to control the

operating pressure of the tool

between 60 and 100 psi.

SINGLE SEQUENTIAL MODE

This mode

requires the

trigger to be

pulled each

time a fastener

is driven. The tool can be actuated by

depressing the WCE against the work

surface followed by pulling the trigger.

Operating Instructions

4

www.chpower.com

60 psi

Min.

120 psi

Max.

Recommended Hookup

Quick

Coupler

Air

Hose

Quick Plug

(Optional)

Quick

Coupler

(Optional)

Oiler

Regulator

Filter

150 PSI WP

3/8" I.D.

1 2 3 4 5 6 7 8 9 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare